Overview
A 30 cm long modular podium boom arm with gooseneck top and microphone preamplifier, DPA Microphones' MMP-F30 is engineered for use with any of DPA's d:dictate™ modular microphone capsules. The MMP-F30 comes with state-of-the-art preamplifier design, and features excellent radio frequency rejection thanks to the DPA designed impedance balancing with active drive.
Features
- Maximum speech intelligibility regardless of acoustical environment
- High-gain before feedback leading to fewer speaker placement issues
- Rejection of mobile phone interference
Specifications
- Output Connector: XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
- Low-Cut Frequency, -3 dB: 15 Hz
- Noise with Shorted Input, A-weighted: 0.6 µV
- Output Voltage, RMS: 2.2V
- Output Voltage, Peak: 3.1V
- Type of Electronic Circuit: Active
- THD @ 1VRMS, 1kHz: < 0.2 %
- Dynamic Range: 131 dB
- Output Impedance: 100 Ohms
- Minimum Load Impedance: 2 kOhms
- Current Consumption: 3.5 mA
- Output Balance Principle: Impedance balancing
- Common Mode Rejection Ratio (CMRR): > 40 dB
- Power Supply (for full specifications): 48 V Phantom power (+/- 4 V)
- Cable Drive Capability: 328ft (100m)
