Overview

To be used as hanging mics or unremarkable table mics, the MMP-E preamps can be combined with any d:dicate modular capsule. The MMP-E holds a high quality preamp, split up into an extremely short 12mm housing to attach the capsule to, a 3 meter cable (optional up to 30 meters) and a 3-pin XLR connector. The preamp is ultra transparent and features the DPA designed impedance balancing with active drive to reject radio frequency interference.

Specifications

• Output connector
• XLR-3M
• Pin 1: shield
• Pin 2: signal + phase
• Pin 3: - phase
• Low-cut frequency: 15Hz at -3dB
• Noise with shorted input: A-weighted: 0.6MuV
• Output voltage
• RMS: 2.2V
• Peak: 3.1V
• Type of electronic circuit: Active
• THD: < 0.2 % at 1VRMS, 1kHz
• Dynamic range: 131dB
• Minimum load impedance: 2kOhms
• Output impedance: 100Ohms
• Cable drive capability: 324' / 98.76m
• Output balance principle: Impedance balancing
• Common Mode Rejection Ratio (CMRR): > 40dB
• Power supply: 48V Phantom power (+/- 4V)
• Current consumption: 3.5mA