Overview
The ST4015A Stereo Pair with 4015A Wide Cardioid Microphones from DPA is a stereo kit that consists of two matched 4015A Wide Cardioid Microphones, two microphone holders, two windscreens, and a Peli Carrying Case. The microphones are matched within ±1 dB on both frequency response and sensitivity for accurate
Specifications
| Directional characteristics: | Wide Cardioid |
|---|---|
| Principle of operation: | Pressure gradient |
| Cartridge type: | Pre-polarized condenser |
| Frequency range: | 20 Hz - 20 kHz |
| Frequency range, ± 2 dB at 30cm: | 40 Hz - 20 kHz |
| Sensitivity, nominal+/- 2 dB at 1KHz: | 10 mV/Pa; -40 dB re. 1 V/Pa |
| Equivalent noise level A-weighted: | Typ. 18 dB(A) re. 20 µPa (max. 20 dB(A)) |
| Equiv. noise level ITU-R BS.468-4: | Typ. 25 dB (correct with the attenuator in 0 dB or -20 dB setting) |
| S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL): | Typ. 76 dB(A) |
| Total harmonic distortion (THD): | <1% up tp 139 dB SPL peak |
| Minimum load impedance: | 2 kohm |
| Dynamic range: | Typ. 121 dB |
| Max. SPL, peak before clipping: | 159 dB |
| Output impedance: | <200 ohm |
| Output balance principle: | Impedance balancing with Active Drive |
| Cable drive capability: | 100 m (328 ft) |
| Common Mode Rejection Ratio (CMRR): | > 60 dB |
| Power supply: | 48 V Phantom power (± 4 V) |
| Current consumption: | 2.8 mA |
| Connector: | XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase |
| Color: | Matte black |
